- Start
- GYRO
- GPS
- Satellite Information
- Tracking
- Trim
- Complate
-
Driving On
-
Iinialize
-
Searching
-
Tracking
Welcome to installation wizard
Check list for start.
- Set the IPv4 and ABS port on the network page.
- If there is no header input from GYRO, you cannot proceed.
Antenna connection |
- | Start | |
GYRO mode |
- |
|
|
Heading offset (ship to bow) |
- | ||
Target satellite setting |
- |
|
|
Operating status |
- | ||
Skew mode |
- | ||
Operating mode |
- | ||
Searching function |
- | ||
Tracking function |
- |
GYRO
Reception status |
- |
GYRO Compass Setting
Protocol Type | |||
Baudrate | |||
Direction | |||
Sync Frequency | |||
Converter(°) |
GPS / GYRO Input (PCU, NMEA, GYRO Port)
GPS
Reception status |
- | ||
Input source |
- |
|
GPS Manual Setting
Latitude | ° | ||
Longitude | ° |
GPS / GYRO Input (PCU, NMEA, GYRO Port)
Satellite Information
Modem conneciton. |
- | ||
ABSP function |
- | ||
Modem target message |
- |
|
Receviced target satellite information.
ID | Name | ||
Searching Method | Tracking Method | ||
Threshold | Position | ||
RX Polarity | TX Polarity | ||
TX-RX Pol | Skew Trimming Angle | ||
BUC Lo Frequency | - | LNB Low Lo Frequency | |
LNB High Lo Frequency | LNB Band Selection | ||
SAT TP Frequency | SAT TP Symbol | ||
RollOff | NID |
Manual target |
Satellite Channel (No.79)
Zone | Satellite Name | ||
Longitude (°) | NID | ||
Threshold | Search Reference | ||
SkewOffset | Tracking Reference | ||
LNB Low Lo Frequency(KHz) | LNB V&T | ||
LNB High Lo Frequency(KHz) | Tx/Rx Polarity | ||
TP Frequency(KHz) | Rx Polarity | ||
TP SymbolRate(Hz) | DVB Type | ||
Roll-Off | Tx Polarity | ||
BUC Lo Frequency(KHz) |
Trim
Current offset |
- | ||
Trim |
- |
Check before/after trimming.
Before | Ship to Bow | - | Cage Limit Angle | - |
After | Ship to Bow | - | Cage Limit Angle | - |
Save |
- |
PCU Processing Event